保护继电器的代码表（Protection relay code table）.docVIP

保护继电器的代码表（Protection relay code table） Ordinal device comparison table Ordinal DEVICE action 2 time-delay starting or closing relay delay starting or closing relay function is to provide the desired amount of delay at any time before or after the switch procedure or protection relay system action 3 Checking or interlocking calibration or relay interlocking relay in device, reflect the working position of other components or some element of predetermined conditions, can be used to determine whether a work program to continue, or stop or for some elements of work position and check some predetermined conditions. The master contactor main contactor is a component controlled by element 1 and its equivalent elements, intermediate relays, protective components, etc. Its work is to connect or disconnect the necessary control loop so that the equipment can be put into operation under the specified conditions, or under other conditions and abnormal conditions, to make it out of operation. 21 distance relay distance relay when the admittance, impedance, or reactance of the circuit is increased or decreased to exceed the intended value of the relay. 25 synchronizing or synchronism - check relay synchronization or the same time check relay synchronizing element provides output to close the two loops at zero phase Angle, which does not necessarily have voltage and speed control. In the same period, check the relay to tie the two loops in the specified voltage, difference and frequency. 27 under voltage relay undervoltage relay when the voltage drops to a given value. The 30 annunciator relay signal relay is a non-automatic recombination device, which gives the intuitive display and can complete the blocking function while protecting the element action The power relay of 32 directional power relay is to achieve a certain predetermined value in a given power flow direction, such as the reverse power caused by the motor running out of the engine 37 undercurrent or under power relay