钢筋的计算原理（Calculation principle of steel bar）.doc

钢筋的计算原理（Calculation principle of steel bar） The calculation principle of.Txt7 steel is a Durian warmth of spring; warm is written on the face of the shadow; warming is bound to respond with warmth is strict in demands. The 8 respect is a spring, a spring, a give a person warm tonic column Shuxin pill, a dose of inspiring Based on the =2000mm layer: raft foundation, foundation reinforcement length = base layers of high - layer + bending a+ base length HN/3+ and upper longitudinal reinforcement exposed reinforcement lap length LLE (such as welding, lap length is 0) The raft foundation, 2000mm foundation, inserted reinforcement length = base layer of /2- protective layer + bending a+ base length HN/3+ and upper longitudinal reinforcement reinforcement lap length of exposed LLE (such as welding, lap length is 0) Basement: column longitudinal reinforcement length = basement storey - the first layer is HN/3+ layer HN/3+ layer and the first floor height of longitudinal reinforcement lap LLE (such as welding, lap length is 0) First floor: the column longitudinal reinforcement length = the height of the first floor - the first layer is HN/3+max (two layer is HN/6500, the column section size (cylinder diameter) +) and two layers of longitudinal reinforcement lap length LLE (such as welding, lap length is 0) The middle layer: column longitudinal reinforcement length = two storey -max (size two storey HN/6500, column section (cylinder diameter) +max (size three) layer of HN/6500, the column section (cylinder diameter) + three) and LLE layer (such as welding lap, lap length is 0) Top floor： Column: lateral reinforcement length = top layer of max (the floor height HN/6500, column section size length (cylinder diameter)) - beam +1.5LAE The top layer of reinforced length = max (the floor height HN/6500, column section size length (cylinder diameter)) - beam +LAE The anchoring length: When the column longitudinal reinforcement in beams into diameter LAE, using bending anchor column