钢筋电弧焊（Steel arc welding）.doc

钢筋电弧焊（Steel arc welding） Basis concrete structure construction quality acceptance GB50204-2002, JGJ18 Specification for welding and acceptance, bold in the mandatory provisions must be strictly enforced. A, construction preparation 1, mechanical equipment The main equipment is electric arc welding arc welding machine. Arc welding machine can be divided into two types of AC and dc. AC arc welding machine commonly used types are: BX l20-l, BX 300-2, BX - 500 and BX - 2 l000. DC arc welding machine commonly used types are: AX L65, AX 300 1, Ax 320, AX 300, AX 500 etc.. 2. materials Steel: steel of various specifications, grade, must have factory certification, after entering the physical performance test for steel imports to increase the performance of chemical inspection, after passing through the test, can be used. Electrode: according to the relevant provisions of the steel structure engineering implementation, classification, grade electrodes should be placed in a well ventilated and dry warehouse, an important engineering electrode, to maintain a certain temperature and humidity (general temperature 10 to 15 DEG C, relative humidity is less than 5% is appropriate), before welding is usually 20 ~ 25 DEG C oven drying. 3. operating conditions 1) the welder shall by training and examination certificates. 2) arc welding equipment intact, welding machine according to the provisions of the correct power, meet the requirement of power supply welding requirements. Two, operation process Arc welding of reinforcing steel bar points help welding, welding, groove welding and melting tank help four kinds of welding joints. 1, help the welding process (1) when not double welding, one side welding can be used, but help to increase the length of double double welding. (2) for welding is suitable for I, II and III reinforced connections, help should be adopted and the main bar the same level with the diameter of steel production, the key points of the operation are as follows: 1)