经编机代码（Warp knitting machine code）.docVIP

经编机代码（Warp knitting machine code） The machine code of warp knitting machine knitting machine needle to needle to the said unit on the length of the. E (machine number) =L (per unit length, 25.4mm (/T inch) gauge unit is mm) The definition and weft knitting machine knitting machine, machine of the same, but different in length are selected. For different warp knitting machine, the needle bed length has the following provisions: (1) 1 inches: a method commonly used in modern warp knitting machine with E28, which is 28 needles per inch. (2) 30 mm: domestic Z303 by 30mm, 32 pin /30mm, 24 pin /30mm. (3) 1 inch (German DIN, 23.6 mm): the previous old machine use, now no longer in use. (4): 25mm stitch machine use, general F said cases of 12F, 12 pin /25mm. (5) general use tube pipe from said knitting machine, 3 cases, 5, 7, 10mm. (6) on raschel machine, with a needle to earlier 2 inches of said machine number, namely 50.8mm needle needle within the machine number number as shown by ER, ER32. Now use the needle to 1 inches of said. For example, machine No. 24, is written in E24. Machine, warp knitting machines generally use the E14, E18, E24 three. Only the MRE32/24SU E28 machine no.. Machine, jacquard warp knitting machine is sometimes expressed as E6/12, E7/14, E9/18 and E12/24. This means full comb machine configuration, and jacquard comb half machine configuration. In addition, the RJWB series machine, denoted as E24/12, which means full comb machine configuration, and jacquard comb half machine configuration. In addition, the use of its products, machine, general E14 and E18 used in the production of curtains and tablecloth, E18 and E24 used in the production of lace and lace clothing. The machine and the machine working width, the wider the width, the lower machine no.. The general model of warp knitting machine is composed of a set of letters and numbers, to reflect the structural characteristics, the performance of the machine and the types of products. With the em