焊工技师论文（Welding technician paper）.doc

焊工技师论文（Welding technician paper） The welder technician Flame welding deformation of steel structure construction method of correction Abstract: Based on years of experience, combined with the domestic related information, expounds the main types of steel structure deformation, the welding deformation of the construction method of flame rectification. Keywords: Flame rectification construction method of welding deformation At present, the steel structure has been widely used in the construction of the plant. The main component of steel structure workshop is welded H steel columns, beams and braces. These components are the welding deformation problem in the production process, if the welding deformation not be rectified, it not only influence the overall structure of installation, but also reduce the safety and reliability engineering. The welding deformation of steel structure produced more than technicaldesign allows the deformation range, should try to rectify the meet the requirements of product quality. Practice shows that most of the deformation of the component can be corrected. Correction methods are trying to create new deformationto achieve offset has occurred. The correction method is widely used in the production process, mainly mechanical correction, flame correction and comprehensive correction. But the flame correction is a difficult operation, master the methods, improper temperature control will result in greater deformation of new members. Therefore, the flame correction should have rich practical experience. The steel structure welding deformation type correction method makes a rough analysis. Welding type and flame deformation correction of 1 steel structure The main component of the steel structure is welded H steel columns, beams and braces. The welding deformation often adopts the following three kinds of flame correction methods: (1) linear heating method; (2) dotheating method; (3) triangularheatmethod. The following introduces construction m