标签印刷制版工艺（Label printing process）.docVIP

标签印刷制版工艺（Label printing process） Label printing process Label printing covers several major printing methods, in the plate making stage, according to the different nature of the product, choose different printing methods, for different printing methods, plate making process is also different. In this paper, the flexible plate making process is taken as an example. Flexible plate making process is: the original film (Yin piece), one exposure, one rinse, one drying, one after treatment. 1. originals. The original design for the flexible printing should have the following characteristics: the color number contained less; does not require special reproduction of small details; the cable is not too high, but can achieve color printing effect; can do online packaging processing. 2. film (negative). Meet the plate needs, by a clear, accurate size specifications; with matte film, film requires four corner density; using the membrane with orthographic; transmission density gauge, white density is below 0.06; black density is above 3.5. 3. exposures include back exposure and primary exposure. Label printing Back exposure. The support plate of the photosensitive resin plate is upward and the protective film is downwards tiled in the exposure drawer for exposure. UV light solidifies the photosensitive adhesive layer through the support film to establish a solid base, as well as to control the depth of the plate and to strengthen the adhesion between the support film and the photosensitive resin layer. The back exposure time is determined according to the required base thickness. Main exposure. Also known as positive exposure, photosensitive resin plate support film down, protective film upward. The tile in the exposure drawer. The protective film for a tear, then the film Yaomo face pasted on the photosensitive resin plate. The vacuum film flat cover Yu Feilin (non membrane surface), vacuum, film and the photosensitive resin layer is tightly attached. The ultraviolet ray passes