机械平面图画法（Mechanical drawing）.doc

机械平面图画法（Mechanical drawing） CAD plane drawings 2010-02-21 17:40 A shortcut L:line line C: circle round Rec: rectangle rectangle A: arc arc Po: point Dli: dimension dimension The Pr: properties property La: layer layer Lt: linetype line Mi: mirror image M: move Mobile Tr:trim clipping X: explode explosion Co: copy copy F: fillet chamfer Ar: array array I: insert insertion B:block block F3: object capture F8: orthogonal switch F6: coordinate switch Ml: mline painted wall Mledit editor: Wall Ddptype: set point style Ctrl+Tab switching window 1, the input mode: 3) absolute coordinates: X, y 4) relative coordinates: @x, y 5) relative polar coordinates: @ distance angle 6) arrow line drawing: DIM - L The input angle: Direction: clockwise counterclockwise is positive, negative. 0 degrees to the positive X axis, namely the right level direction Two basic requirements, architectural drawing: 1, drawing a: Preliminary design: general layout, main flat vertical profiles Construction design: facilities, facilities, facilities, facilities. 2, map: A0 (841X1189), A1 (594X841), A2 (420X594), A3 (297X420), A4 (210X297) Figure 3, line B (2, 1.4, 1, 0.7, 0.5, 0.35): solid line solid line fine line: =1:0.5:0.25 4, h=3.5, 5, font: 7, 10, 14, 20) b=0.7h 5, the proportion of Architectural Drawing: common ratio: 1:20, 1:50, 1:100, 1:200, 1:500 The proportion of the word high should name words high than smaller or two, such as: plan 1:100 6 dimensions: the dimensions on the drawing, including: the size, size, size boundary line symbols and dimension digital check. Note: 1) radius, diameter, angle and arc length size check symbols, should be represented by an arrow. 2) a set of parallel dimension lines, distance contour pattern should not be less than 10mm, distance between parallel lines should be 7~10mm. 7, symbol: 1) cutting symbol: including cutaway section and section cutting symbol symbol. A) section cutting symbol: cutting position line (6~10mm) and the direction of projection line