fanuc和siemens系统参数修改刀补倒圆角宏程序.docVIP

? 西门子参考程序： M03S2500; G90G54G64G00X0Y0Z50; G01X54.749Y23.251F200;? 下刀点 G01Z5; R1=90; 赋初始值 KK: R2=6*COS(R1)-4;? 刀补值，为刀具中心距离轮廓线的垂直距离，6是刀具与圆角的半径之和 R3=6*SIN(R1)-4; 每一圈加工时的下刀深度，当对球刀时为球刀最低点时，-4，当对刀点为球刀中心时，则-6 $TC_DP6[1,1]=R2;???设定刀补值，1号刀1号刀补 G01Z=R3F100; G42G01X54.749Y3.251D1; G02X34.749Y23.251CR=20; G03X22.749Y35.251CR=12; G01X-2.852Y35.251; G03X-14.251Y27.001CR=12; G02X-27.001Y14.251CR=20; G03X-35.251Y2.852CR=12; G01X-35.251Y-22.749; G03X-23.251Y-34.749CR=12; G01X-2.692Y-34.749; G02X-0.25Y-35CR=12; G03X13.652Y-26.813CR=12; G02X26.813Y-13.652CR=20; G03X35Y0.25CR=12; G02X34.749Y2.692CR=12; G01X34.74