APPENDIX E SIZING OF WATER PIPING SYSTEM （附录E上浆的水管道系统）.pdf

APPENDIX E SIZING OF WATER PIPING SYSTEM SECTION E101 istrative authority. The sizes selected must not be less than GENERAL the minimum required by this code. E101.1 Scope. E103.2.2 Water pipe sizing procedures are based on a sys- tem of pressure requirements and losses, the sum of which E101.1.1 This appendix outlines two procedures for sizing must not exceed the minimum pressure available at the sup- a water piping system (see Sections E103.3 and E201.1). ply source. These pressures are as follows: The design procedures are based on the minimum static pressure available from the supply source, the head changes 1. Pressure required at fixture to produce required flow. in the system caused by friction and elevation, and the rates See Sections 604.3 and 604.5. of flow necessary for operation of various fixtures. 2. Static pressure loss or gain (due to head) is computed E101.1.2 Because of the variable conditions encountered in at 0.433 psi per foot (9.8 kPa/m) of elevation change. hydraulic design, it is impractical to specify definite and Example: Assume that the highest fixture supply detailed rules for sizing of the water piping system. Accord- outlet is 20 feet (6096 mm) above or below the sup- ingly, other sizing or design metho