Belt Drive Conversion Kit for the Mini Mill（小型钢铁厂的皮带传动转换工具包）.pdf

The premier source of tooling, parts, and accessories for bench top machinists. Belt Drive Conversion Kit for the Mini Mill This kit provides an easy-to-install alternative to the noisy factory-equipped gears that drive the spindle of SIEG model X2 mini-mill machines. Switching to a belt-driven spindle also eliminates down time caused by broken motor or speed change gears. During the design of this retrofit the speeds of the high and low setting were enhanced to allow for a wider range of RPM low range and a higher top speed in the high range. This allows almost all standard milling and drilling to be performed in the low setting with speeds of 0 to 1700 RPM . The high speed setting of between 0 and 4300 RPM can be used for very small end mills or drill bits, or carbide engraving bits. This provides new and exciting uses for your mini mill. These ruggedly made kits are CNC machined from the highest quality materials, supplied with all the necessary fasteners and a belt. This kit was designed to be used full time so it is built to last. Changing speed ranges is accomplished by removing the guard, loosening the motor plate lever lock and moving the loosened belt from one set of pulleys to the next. No tools are required for changing belt positions. The installation is bolt-on and should take ten to fifteen minutes to complete . You will need the following tools :  Hex wrenches: 3 mm, 4 mm, 5 mm, and 3/32  Retaining-ring pliers or needle nose pliers  Phillips screwdriver  Blade type screwdriver  Spanner wrench (furnished with your mini mill)  Spindle lock pin (furnished with your mini mill) Before starting please read and understand all steps of the installation instructions. One more thing to consider before you begin: Although it’s not necessary, you can remove the original speed selection lever and gear