Construction Notes for the Mini2V CO2 （建设笔记Mini2V二氧化碳）.pdf

Construction Notes for the Mini-2V CO2 compressed air engine. 9/9/2003 This is a set of photos and notes that should help better understand the parts and drawing used in this engine. The rough cylinder. Square steel key stock was used for the cylinders. Keep inside flange long to hold in Fins were cut with a slitting saw blade held like a cutter. The bore was drilled chuck while drilling head and exhaust holes. Turn to length later. The ID slightly undersize. Counter bore was added for the valve disk. The Inside needs a champher for connecting rod clearance. was honed with 400 grit lapping compound until a section of ¼ drill rid fit in, then that was lapped to perfect fit. Page 1 of 8 © David Kerzel, 2003, all rights reserved. Construction Notes for the Mini-2V CO2 compressed air engine. 9/9/2003 Rough bore the inside using 4 jaws. Drill the mounting holes. Later using a 1/16 diameter burr, angle and elongate the holes so the screws will enter. Turn to correct diameter and depth holding bearing boss to improve concentricity. Use light cuts so it will not slip. Turn bearing boss. Page 2 of 8 © David Kerzel, 2003, all rights reserved. Constr