E L L I O T T Beagle（E L L I O T T 小猎犬）.pdf

OPERATORS INSTRUCTION HANDBOOK FOR THE E L L I O T T HIGH SPEED SHAPING MACHINES MODELS 14M, 18M 24M Also COMPONENT PARTS LIST Contents Page Slinging 2 Examination 2 Cleaning 2 Installation 3 Foundation 4 Lubrication 5 Operating instructions 8 Wiring 10 Maintenance 10 Extra equipment 12 Specification 16 Slinging In order not to disturb the alignment of the machine, care is required when lifting, and the method shown in figure 1 should be employed. Examination The machine should be carefully examined on arrival and any damage sustained in transit reported immediately to the responsible authority. Cleaning All bright surfaces are covered with a rust preventative which is soluble in ordinary machine oil. Do not allow the sliding members to be moved until all the protective material has been removed and use only lubricating oil for this purpose. Insta ation Figure 2 shows the Foundation Plan which gives all the required dimensions for installation. In order to ensure accurate and efficient operation, the machine should be correctly levelled and bolted to a good concrete foundation. Before levelling, a swivel table should be clocked square with the top surface of the cross slide. A precision level should be used for levelling th