AN1951LM3000 Evaluation Board Texas （德州AN1951LM3000评估板）.pdf

Users Guide SNVA389A– July 2009– Revised May 2013 AN-1951 LM3000 Evaluation Board 1 Introduction The LM3000 evaluation board is designed to provide the design engineer with a fully-functional power converter based solution using Dual Output Emulated Current Mode Controller in LM3000. This evaluation board provides two output voltages of 3.3V and 1.2V. The 3.3V output is designed to handle a maximum current of 8A; whereas the 1.2V output has a maximum current capability of 15A. The switching frequency for the converter is set at 500 kHz. The gate signals for each output voltage will be 180 degree out of phase from each other. The printed circuit board consists of 4 layers of FR4 material with 2 ounce copper on top and bottom layer and 1 ounce copper for internal layers. This application note contains the evaluation board schematic, bill of materials (BOM) and a quick setup procedure. Refer to the LM3000 Dual Synchronous Emulated Current-Mode Controller (SNVS612) data sheet for complete circuit design information. The performance of the evaluation board is as follows: Input Range : 6V to 18V Output Voltage 1 (VO1) : 3.3V Output Current 1 : 0 to 8A Output Voltage 2 (VO2) : 1.2V Output Current 2 : 0 to 15A Switching Frequency : 500 kHz Load Regulation