BRAKE NOISE Solutions FederalMogul （制动噪声的解决方案FederalMogul）.pdf

WAGNER BRAKE PRODUCTS BRAKE NOISE -Solutions All sound is the result of a vibration. The pitch is determined by the frequency of the vibration. This means a slow vibration sounds like a groan, while a fast vibration will sound like a squeal. A vibration in one part can induce a secondary vibration into another part, particularly as parts are lighter each year and resonate easier. In most O.E. brake designs, dampening is performed by clips to assure rigidity or by insulator shims behind the pads. The two ways to solve noise are: DAMPEN VIBRATION -O.E. KITS -Some specific models require a tuned dampener assembly from the manufacturer to eliminate the secondary resonant frequency vibration. -EMP COMPOUND -Put on a heavy bead of cushioning material or spray behind the pads and let dry , to form an absorbing cushion at the pad-to-caliper contact points. -SHIM INSULATORS -Forms a permanent cushion to dampen vibration; inner layer of spring steel resists wear, while the outer rubberized cushioning nytrile layers will last the life of the pads. -HI-TEMP GREASE -Use high temperature silicon grease on caliper slides, and on floating pins to prevent caliper binding and chatter. PREVENT VIBRATION -PAD TABS -Bend any tabs or ears on the pads, to make sure that the pads; are tight in the calipers. , -ROTOR FINISH -Sand rotor smooth and flat using 120 to 150 grit sandpaper, to get the full pad surface contact, while preventing grab and chatter . -CLEANING