对接焊缝射线检测工艺规程NDT.docVIP

CONTROLLED □ UNCONTROLLED □ COPY NO.: RT EXAMINATION PROCEDURE 5 4 3 2 1 0 陈鑫亮2015.01.06 钱辉2015.01.06 REV.NO. PREPARED BY APPROVED BY NDE LEVEL Ⅲ 1 General 1.1 This procedure is applied to the x-ray radiographic examination of butt welds for pressure vessels constructed in accordance with ASME Code Section Ⅷ Div1, 2010 ED. and 2011 AD. 1.2 This procedure shall be supplemented, when necessary, with the examination instructions defining more specific variables, which will be prepared by NDE Level Ⅲ personnel. 2 Qualification of Examination Personnel 2.1 Any person engaged in radiographic examination shall be qualified and certified as a radiographic examiner in accordance with BAOSE’s “Written Practice for NDE Personnel Training, Qualification and Certification”(QCND-011). 2.2 The NDE LevelⅠshall receive the necessary instruction or supervision from a certified NDE LevelⅡ or LevelⅢ Examiner. The NDE LevelⅡ shall receive the instruction or supervision from a NDE Level Ⅲ Examiner. 2.3 According to the respective responsibility range, all examiners shall complete the examination conforming to the referencing ASME Code Sections, standards and written instructions. They shall assure the working quality. 3 Equipment, Tools and Materials The LevelⅡExaminer shall select the equipment, tools and materials to assure that they are in compliance with the following conditions and the requirement of the examination instruction. 3.1 One of the x-ray equipment shall be selected from Table 1. Table 1 Type Manufacture Max. Tube Voltage(KVp) Max. Tube Current(mA) Focal Size (mm2) Permitted max. Steel thickness (mm) XXQ1605 Dandong 160 5 0.8 9 XXG2505 Dandong 250 5 2 39 XXQ3005 Dandong 300