暖气知识（Heating knowledge）.docVIP

暖气知识（Heating knowledge） We must understand that we are dealing with the high temperature water system and the cryogenic water system at the moment. Strict design is absolutely correct and necessary. Condensation problem: condensate is an important cause of corrosion of gas-fired hot water heating furnace. The main component of natural gas is methane, whose combustion products are carbon dioxide, water vapor, nitrogen oxides and a small amount of carbon monoxide. Burning 1Nm3 gas produces about 1.5kg of water vapor. Flue gas dew point temperature is about 55~58 degrees Celsius, when the stove inlet temperature is low, the flue gas will encounter below the dew point temperature of the heating surface and condensation (followed by evaporation), weak acid condensed water is more corrosive to carbon steel, affect the service life of the furnace. The household gas-fired hot water heating furnace circulating water under low temperature, especially water temperature of radiant floor heating or air conditioning system, generally less than 50 degrees Celsius, the allocation of more, and when the radiator heating load is small, the room temperature control is required to reduce the water temperature, so the condensation phenomenon is relatively common. Although some products with low temperature limiting device, when the water temperature is below a set value of the lower limit, the circulating water pump to stop running, but because the water capacity of the stove body is very small, a shoot quickly stop the pump temperature rise, circulating water of the start and stop frequently, and can not solve the problem fundamentally dew corrosion. We should take some effective measures, such as: water mixer system with small temperature difference, can also be used as a device to enhance the furnace inlet temperature, which can be in the mixer in the furnace and water mixing system as water backwater, stove, design of a complete set of thermostatic system and two circulation system i