浅谈ps版的毛面层技术（Elementary introduction to the coat surface technology of PS edition）.doc

浅谈ps版的毛面层技术（Elementary introduction to the coat surface technology of PS edition） The PS version of the.Txt11 wool surface layer life is the flower, it was a beautiful shine, stretch, beautiful and more funding; life is beautiful, fresh and smooth, meaning long; life is beautiful music, melodious melody and harmony; life is a flowing river, flowing endless, hair surface rolling forward the PS version of the layer technology The hair surface version of the PS (mat layer) is mainly used in the surface of the photosensitive layer, is composed of numerous discontinuous hair surface particles (mat particles) composition, its role is to reduce the contact exposure need vacuum contact time, and prevent the image blur. Vacuum tight time refers to the PS print process of vacuum, film and PS version of the photosensitive layer surface to completely close contact time needed. The PS plate is made by contact exposure, and the process is as follows. In the process of graphic exposure, the film is first covered on the surface of the PS version, and then the image of the film is projected onto the photosensitive layer of the PS version by printing the light source. In order to obtain a clear image, the film and PS photographic layer should be attached to the exposure without voids. Therefore, the vacuum suction frame is usually used to place the film and the PS plate between the glass plate and the rubber blanket of the vacuum frame of the printer, and then vacuum to close the film and the PS plate. But the exposure, due to a smooth surface PS version, PS version of the film and the photosensitive layer sealing part of the edge is easy to close out, is not conducive to the middle part of the air, resulting in vacuum for a longer period of time, greatly reduce the efficiency of plate making operation; and sometimes after a long time, not to air. Due to the widespread use of domestic offset printing plate is positive version of PS, when exposing the photosensitive resin will decompo