液压压力传感器（Hydraulic pressure sensor）.docVIP

液压压力传感器（Hydraulic pressure sensor） HYDAC (He Deke) hydraulic pressure sensor 1. overview The hydraulic pressure sensor is one of the most pressure sensors used in the industry practice, which is widely used in various industrial control environment, involving oil pipelines, water conservancy and hydropower, railway transportation, intelligent buildings, production automation, aerospace, military, petrochemical, oil, electric power, shipbuilding, machine tools, air duct, negative pressure boiler etc. industry. 2. working principle The working principle of the hydraulic pressure sensor is pressure directly on the sensor diaphragm, the diaphragm will produce micro displacement is proportional to the medium pressure, the sensor resistance changes, and the electronic circuit used to detect this change, and convert a standard signal output corresponding to the pressure. 3. correlation parameter A, pressure range (German druckbereich):-0.1 ~ 0~1 ~ 1000 (MPa) 1 BA (bar) =100 (KPa) =10 Newton kPa / cm2 =0.1MPa bar is pressure units, previously used in meteorology mbar, now use international unit equivalent hpa. 1 pa is the abbreviation of 1 Pascal, that is, one square meter is under the pressure of one newton. The project is still in use in this unit kilogram force, 1 kilograms force equal to 9.80665 Newton, resulting in engineering atmospheric pressure: 1 Engineering atmospheric pressure =1 kg / cm2 =0.967841 atmospheric pressure =98066.5 mm Hg Pascal is also a common unit of pressure, the pressure generated by the definition of the unit of pressure of 1 mmHg for support (Torr) 1 Torr =1 mm Hg =133.32 Pascal 1 atmospheric pressure =760 support B, comprehensive accuracy: 0.1%FS, 0.25%FS, 0.5%FS (FS is Full Scale, meaning is full range of a few percent) C, output signal: 4 ~ 20mA (two-wire system), 0 ~ 5V, 1 ~ 5V, 0 ~ 10V (three wire system) D, supply voltage (German: Versorgung), 24DCV (9 ~ 36DCV) E, medium temperature: -20 ~ 85~150 DEG C F, ambient temperature: normal tempe