硬质合金焊接技术（Cemented carbide welding technology）.doc

硬质合金焊接技术（Cemented carbide welding technology） 1 Introduction The whole hard alloy tools in the aerospace industry, mold manufacturing, automobile manufacturing, machine manufacturing and other fields have been widely used, especially in high speed cutting plays a more and more important position in the field. In the field of high speed cutting, due to the high safety requirements of the safety, reliability and durability of the tool, the quality requirements of the internal and surface of the whole cemented carbide tool are more stringent. With the continuous improvement of the internal quality of cemented carbide bars, especially superfine cemented carbides, the quality of cemented carbide tools has been paid more and more attention to. As everyone knows, the hard alloy tool life in addition to the outside and wear resistance, is often manifested in chipping and fracture, the broken blade and other non normal failure, after grinding tool grinding cracks is one of the important reasons causing the non normal failure. These surface defects include after grinding exposed to the surface of the hard alloy bar internal powder metallurgy manufacturing defects (such as delamination, crack, no good hole) crack defects caused by grinding grinding is not reasonable in the grinding surface and due to the grinding process and the grinding crack is more common. The grinding crack, with eyes and enlarge routine mirror, blowing sand, oil immersion microscope and tool microscope tend to cause missing, missing tool in use especially in high speed cutting situations may cause serious consequences, so the whole hard alloy tool products grinding crack great harm. Therefore, the causes of grinding cracks of cemented carbide tools are analyzed and discussed, and the effective measures to prevent grinding cracks are put forward, which has important practical significance. Analysis of the causes of grinding cracks in 2 carbide tools Grinding characteristics of solid carbide cutting tools B