检验误差（Inspection error）.docVIP

检验误差（Inspection error） In the quality inspection process, there are many factors that influence the quality of inspection, but according to the survey research shows that the test error of inspection personnel accounted for the vast majority, making preparations for inspection of quality characteristics of the defect was 80%, that is to say, inspection personnel can only pick out the actual defects in 80%, and missed the rest of the 20%. In view of this, enterprises should improve the overall economic benefits at the same time, do not ignore the error caused by loss of quality inspection personnel of the inspection. The status of quality inspection work is investigated and analyzed, and feasible improvement measures are put forward to improve the quality of products so as to improve the effectiveness of quality inspection work. First, the concept of error detection 1. truth (Y): the true value of being measured (either geometric or other physical quantities). 2. test error: the difference between the measured value and the true value being measured. Which is defined as Y = y-Y The Y test: y test error for measured value * none of the tests can verify the truth value because the inspection error is unavoidable. * the measurement accuracy of geometric quantities is usually expressed as absolute error, and the relative errors of electronic quantities are used. 3. factors that produce inspection errors (L) inherent errors of measuring instruments (2) the error brought by measurement standards (3) the error caused by the object under test (4) environmental factors affect the error (5) the error introduced by measuring method (6) the human error error of the operator Two, inspection personnel to produce inspection error characteristics and prevention measures The inspection errors of the inspection personnel are mainly wrong check and missed inspection. The types of its produce are: 1. technical errors of 2. 3. procedural errors of 4. be negligent error knowingly violate