模具2d流程（Die 2D process）.docVIP

模具2d流程（Die 2D process） The mold design process and basic knowledge 2D die drawing process: 1.UG: after drawing mold, mold and side view (reaction product features: parts of the line position, slant column, etc.), is a side view. 2. the UG derived view is copied to the CAD standard frame, save for the products or the mold number, the product map layers, make layer block, rectangular frame of a mirror, shrink, maximum dimension mark product. No. 3.: find the benchmark products (with the characteristics of some products, such as the center column), the multimode products ranking by the translation or rotation mode, place is the need to consider the product positioning screws into the plastic, water, mold, parting surface, cavity size determination. 4. side view painting line, after the model view lines, layering, pillar die machine, shovel. Note:.5 between A, line and ear (template in the template to avoid empty) B, layering is generally lower than the template.2 (in the strip to avoid air) C, a fixed die 1 (in the unilateral obstacle space template to avoid empty) D, a shovel is generally higher than for single small 1-2, the bottom line than the tail high 1-2 (shovel gap) E, a front end to insert 3 pitch into fixed mold need to do 3 degree inclination F, a shifting block, avoid empty T block is the same, depending on the actual circumstances The 5. part draw oblique top. 6. cut insert: needle, local deep rib made of inserts. 7. channel, gate. 8. draw water, rows of screw (inserts, screw water, not dry). The 9. row (water, screw, thimble thimble can not dry). 10. draw standard parts (push plate guide pillar, supporting head, limiting column, spring, screw, high garbage Ding, K.O. holes) 11. standard number: dynamic water, screw, product and mold opening reference frame, line center line, standard position (spring, closure, limiting column, prop head, push plate guide pin, a positioning block, rod shape, mold frame, etc.). Die: water, screw, product and mold opening re