法拉克维修常用的参数（Falak commonly used maintenance parameters）.docVIP

法拉克维修常用的参数（Falak commonly used maintenance parameters） Franke numerical control system maintenance commonly used parameter 2008-05-12 15:12 Categories: default classification size: large, medium, small, FANUC system has a wealth of machine parameters, for CNC machine tools installation, debugging and routine maintenance brings convenience. According to the practice for many years, this paper introduces the application of common machine tool parameters in maintenance. 1. hand pulse generator is damaged. A FANUC 0TD CNC lathe, hand pulse generator failure, so that the tool can not be fine-tuning, the need to replace or repair faulty parts. At that time, there was no suitable spare parts. The parameter 900#3 was set to 0, and the manual pulse generator was not used, instead of using the inching button and the single pulse generator to do the tool trimming. After the hand pulse generator is repaired, the parameter is set to 1. 2. when the machine tool starts to return to the reference point, the ultra trip alarm appears. When the machine tool returns to the reference point, there are 510 or 511 redundant alarms, and there are two kinds of processing methods: (1) if the X axis appears in the process of returning to the reference point, the 510 or 511 pass alarm can change the parameter 0700LT1X1 value to (or modify the 0704LT1X2 value to , and then return to the reference point again. If there are no problems, change the parameter 0700 or 0704 to the original value. (2) press the P and CAN keys at the same time, then you can eliminate the overshoot alarm. 3., a FANUC 0I CNC lathe, ALM701 alarm shortly after the boot. From the maintenance manual interpretation of content for the upper part of the fan overheat control, open the machine electrical cabinet, check the fan motor action, check the fan power supply is normal, can determine the fan is damaged, because of a moment not to buy the same type of fan, the first parameter RRM8901#0 to 1 before the re