浅谈某教学楼工程加固加层改造设计（Add layer reinforcement and transformation design of a teaching building on Engineering）.docVIP

浅谈某教学楼工程加固加层改造设计（Add layer reinforcement and transformation design of a teaching building on Engineering） Add layer reinforcement and transformation design of a teaching building on Engineering Abstract: with the rapid development of the national economy, people on the production and living conditions gradually improved, increasing the identification and reinforcement of existing buildings structure. Based on the frame structure of a school of engineering reinforcement design examples, the design of the connection between the old and the new structure design of the layer. Keywords: building engineering; reinforcement design; 1 project overview A teaching building project in Guangdong Dongguan, built in 2000, for the cast-in-place concrete frame structure, no basement, ground floor of 3 storey, respectively 4.5, 3.9, 3.9m, total construction area of 2300m2, on the roof. The foundation of building with reinforced concrete independent foundation, buried depth of 2m, down to the silty clay layer is 190kn/m2, the characteristic value of bearing capacity. Because of the change of function, in the original structure with 2 layers as a student activity center and dance studio, 2009 design reinforcement and add layer to the dining room, adding part storey is 3.9m. 2 of the original structure safety checking and overlay scheme selection 2.1 settlement observation and bearing capability of foundation The foundation of the building is relatively uniform, the settlement data and the completion of the settlement observation data comparison found little change, the foundation has stabilized, not found in the uneven settlement of the situation. 9 years since the completion of the project, silty clay foundation become compact and its endurance by relevant information can be improved by 20% to 30%, but due to the incorporation of the two level, experience, part of the foundation of the foundation bearing capacity is still insufficient, need to take reinforcement measures. Bearing cap