焊工培训题目（Welder training subject）.docVIP

焊工培训题目（Welder training subject） Exercise one A. Completion The 1 is through welding (heating) (or pressure), or both, and (with or without the use of filler material), the workpiece to reach a combined method 2 are in accordance with the metal in the welding process and process characteristics, can be divided into welding method (melting), (pressure welding) and (brazing) The 3 is the biggest harm defects (crack) 4 is the use of gas (gas) and combustion gas mixed combustion flame to melt the workpiece at the joint of the metal wire and the metal is firmly connected to method 5 is the essence of the metal cutting process of iron in pure oxygen in the combustion process According to the 6 different mixed oxygen and combustible gas ratio, gas welding flame can be divided into neutral flame, carbonizing flame and oxidizing flame The 7 electrode arc welding arc method and scratch method was two 8 FCAW is essentially a method of welding slag gas protection 9 plasma arc welding by mechanical compression, thermal compression, and three kinds of magnetic compression compression effect, the concentration of energy, high temperature plasma arc, arc stiffness 10 chemical and fuel container and pipe welding, the displacement welding with pressure and displacement welding two methods 11 burning three conditions must also have the combustible material, combustion and fire source material Two multiple-choice questions 1 is the best performance of the carbon steel welded steel C A A B low carbon steel in high carbon steel The 2 is to increase A, weld depth and weld reinforcement will increase, and the weld width is almost unchanged A welding current B arc voltage of C welding speed 3 is the C cutting process of C preheating combustion slag The main risk is the B 4 welding and cutting of fire and explosion 5 widely used underwater flame cutting flame B oxyhydrogen flame 6D does not burn, but to combustion, is a strong oxidizing agent D oxygen 7 acetylene generator safety device can e