电动车的接法（Connection of electric vehicles）.docVIP

电动车的接法（Connection of electric vehicles） 1. the battery cannot be charged or charged. 1 battery life terminated: replace or repair batteries; 2 fuse in the battery fuse: replace the fuse; 3 the contact between the battery pipe and the safety seat is bad: adjust the position to make the contact well, or replace the safety tube; 4 charger no output voltage or low output voltage: replace or repair charger; 5 charger and AC 220V power supply bad contact: re plug the power supply; 6 the charger indicator is abnormal and full of fake: replace or repair charger. 2. the power indicator is not on the instrument panel and the motor is running normally. 1 dial, positive and negative lead wire, no voltage: connector bad contact or lead broken circuit: re insert or change line; 2 LED damage: replace or repair the light-emitting tube; 3 dial circuit breaker: replace or repair instrument circuit board. 3. when the motor rotates, stops. 1 the battery is low: charge the battery; 2 the battery contact is bad: adjust the contact position or polish contact; 3 the contact between the pipe and the safety seat in the battery box is bad: adjust or replace it to make it good; 4 speed hand in photographic film tube with a photosensitive dirt: cleaning or replacement of photographic film, wipe the photosensitive tube, still can not rule out the fault: replace the speed regulating handle; 5 there is a malfunction in the controller: replace or repair the controller; 6 speed control, the handle seems to be broken off: change or repair the lead; 7 brake power switch out of order: adjust or change the brake power off switch; 8 power supply lock, poor contact after ablation: replace or repair power lock; 9, the line of plug-in virtual connection: re plug, so that it is in good contact; 10 motor carbon brush, wire winding, weld, repair or replacement of the motor: virtual connection. 4. open the power supply, the controller works normally, turn the handle, the motor does not rotate. 1, check whether