第四章 金属的塑性成型与再结晶（The fourth chapter and recrystallization of metal plastic forming）.docVIP

第四章 金属的塑性成型与再结晶（The fourth chapter and recrystallization of metal plastic forming） A multiple-choice test 1 Full Score: 1 points: the state did not reply to the actual score: Test: 7. in order to improve the mechanical properties of the parts, usually will streamline the hot-rolled bar (fibers) by () A. heat treatment to eliminate B. cutting off The reasonable distribution of C. forging To eliminate D. forging [C.] reference answer the reasonable distribution of forging I [answer] Item 2: 1 points out of the value status: not a actual score: Test: Metal plate stamping parts appear obvious goblet, ear phenomenon, which exists in the metal plate A. texture B. dislocation density is too high Sub grain C. too much D. streamlines (fibers) [A.] the deformation texture I [answer] Item 3: 1 points out of the value status: not a actual score: Test: Cold deformation in the plastic deformation (). A at room temperature B, the crystallization temperature of the following C and below recrystallization temperature D, below zero Reference answer []C, below recrystallization temperature I [answer] Item 4 Full Score: 1 points: the state did not reply to the actual score: Test: In order to meet the requirements of steel cutting, generally the hardness range (about) A.200HBS (HB200) B.HRC35 C.HRB30 D.HRA60 [reference] A.200HBS (HB200). I [answer] Item 5 Full Score: 1 points: the state did not reply to the actual score: Test: The critical points of the need to cut crystal slip measured values than the theoretical calculation of the small stress, indicating that the crystal slip mechanism A. mobile rigid sliding surface B. dislocation movement in the slip plane C. vacancy and interstitial migration D. grain boundary migration [B.] the movement of dislocation in the slip plane I [answer] Item 6 Full Score: 1 points: the state did not reply to the actual score: Test: To make the cold deformation of metal hardness decreases and the increase of plasticity, should be (). A. stress annealing