给水管道（Water supply pipeline）.docVIP

给水管道（Water supply pipeline） 1 material requirements 1.1 cast iron pipe and pipe fittings specifications should comply with the design requirements of pressure, wall thickness, and smooth, no cracks, blisters, burr and lump; inside and outside the socket diameter and pipe fittings should be other rules, coating the inner and outer surface of tube should be clean and uniform, firm attachment. Both pipe and fittings should have factory certificate. 1.2 galvanized carbon steel pipe and pipe fittings of the specifications should be consistent with the design requirements, galvanized pipe inside and outside the uniform, no corrosion, no flying thorn. Tube without partial deduction, arbitrary deduction, incomplete or inaccurate thread angle phenomenon. Both pipe and fittings should have factory certificate. 1.3 water meter specifications should comply with the design requirements and the water company confirmed, hot water system to meet the temperature requirements of the hot water meter. Case casting rules, no blisters, cracks, table glass cover damage, seal integrity, factory certification. 1.4 valve specifications, models should meet the design requirements, hot water system valve meets the temperature requirements. Valve casting rules, smooth surface, no cracks, flexible shape, close tight, packing seal intact, no leakage, hand wheel intact, no damage, there is a factory certificate. 2. main machines and tools 2.1: mechanical threading machine, wheel saws, bench drill, electric hammer, electric drill, electric welding machine, electric pressure test pump. 2.2 sets of tools: wire board, Guan Qian, pressure pliers, hand saw, hammer, wrench, pliers, chain bending machine, hand pump, chisel, hammer, twist off tube etc.. 2.3 other: level ruler, wire drop, steel tape, small line, pressure gauge, etc.. 3. operating conditions 3.1 underground pipeline laying in real backfilling or subsoil must be dug into the tube bottom elevation, along the pipeline laying position to clean u