1材料（1 materials）.docVIP

1材料（1 materials） 1, the porosity of materials: 1 - (apparent density divided by density) multiplied by 100% 2, material water absorption: water saturation when the amount of water inhaled material, dry material and dry mass or volume percentage. 3. Moisture absorption: the weight of a material in an aqueous state minus the dry mass of the material and then divided by the drying quality. 4, cement: dissolution period, coagulation stage, hardening period. Cement coagulation factors: mineral composition and fineness of cement (thin, the surface area is large, the easier the hydration, hardening faster), water (reducing water cement ratio to improve the strength of the cement product, the amount of water to cement hydration, rapid hardening), curing time and temperature (wet moisture hardening, promote improve the strength of gypsum () and mixed too much, quick setting cement, cement expansion damage caused by cutting period; general dosage of cement weight three percent to five percent). 5, 9 technical requirements: Magnesium Oxide, three sulfur trioxide, initial setting time or stability, any inconsistent with the waste; fineness, final setting time, insoluble matter and the amount of burning failure is unqualified. 6, Portland cement corrosion: dissolution of erosion (soft water), ion exchange reaction to produce dissolved in water or loose, non gelling substances, carbonic acid corrosion. 7. Portland cement: Portland cement based, mixed with appropriate amount of materials and appropriate amount of gypsum, made by CO grinding cement. 8. Active mixing materials: granulated blast furnace slag, pozzolanic admixture and fly ash. Non active mixing material of quartz sand, limestone, clay, dolomite and no chemical reaction with the cement industrial waste, in order to increase the output of cement, reduce the cost, reduce the label, heat of hydration, improve the workability of mortar and concrete. 9, ordinary portland cement doped active material when the maximum amount