allegro出gerber（快板出Gerber）.docVIP

allegro出gerber（快板出Gerber） How does Allegro generate a drawing file? Use file file and file system ------------------- film board, finally to board factory files: --------------------------- Ordinary two plywood: Nc_param.txt, Ncdrill.tap (ncdrill.drl) drill tape file Art_aper.txt, (aperture table and light drawing format file) Aperture, and, artwork, format Art_param.txt, (light drawing parameter file) Aperture, parameter, text Top.art, (component surface, routing layer, Gerber file), Top (comp.), side, artwork Bottom.art, (solder mask, routing layer, Gerber file), Bottom (comp.), side, artwork Soldermask_top.art, (component surface, solder mask, Gerber file), Top (solder), side, solder, mask, artwork Soldermask_bottom.art, (solder mask, solder resist, Gerber file), Bottom (solder), side, solder, mask, artwork Pastemask_top.art, (surface mount element surface, welding layer, Gerber file) Top, side, paste, mask, artwork Pastemask_bottom.art, (surface bonding, welding surface, welding layer, Gerber file), Bottom, side, paste, mask Silkscreen_top.art, (component surface, screen printing layer, Gerber file), Top (comp.), side, silkscreen, artwork Silkscreen_bottom.art, (solder resist, screen printing layer, Gerber file), Bottom (solder), side, silkscreen, artwork Drill.art, (drilling and dimensioning documents) Four plates, together with Gnd.art, (internal layer Gerber file) Gnd, layer, artwork Vcc.art (internal power layer, Gerber file) Vcc, layer, artwork Multilayer board, plus Inner.art (internal layer wiring layer, Gerber file) Inner, layer, artwork ----------------------------------------------- than file method MANUFACTURE-ARTWORK-film control-available film- Right mouse button -add (add the required layer) Start layer - right mouse button -add (add subclass) The left mouse button to select - output layer PLOT MODE - POSITVE (such as negative, then select NEGATIVE) GENERAL PARAMETERS-DEVICE TYPE-GERBER RS274X (if all vias are FLASH, optional Gerber 6x00 devices