数控加工工艺作业（NC machining operation）.docVIP

数控加工工艺作业（NC machining operation） NC machining operations (3) The fourth chapter based on the NC machining process A single choice: 1.D2.A3. C 4. B 5. D 6. B 7. D8.C9.D10.D Two, to determine the problem 1. V 2. x 3. x 5. x 6. * 4. * 7. * 8. * 9. * 10. * Three, short answer questions 1, what is the process and working step? What is the principle of division? Answer: 1. The mechanical process, one or a group of workers in a work place, part of the process of one or a group of workpiece continuously done, called process. The process division is based on whether the change in work and work is continuous. Part of the station to complete without changing the machined surface, the cutting tool and the cutting parameters under the condition of the content is called step. Divide step is based on the machined surface and tool change. The principle of process division The process principle: each process includes processing the content as much as possible, not suitable for mass production. The process of dispersion principle: workpiece machining more dispersed in the process, few processing content of each process. Suitable for mass production. 2, the NC machine tool parts, according to the general principles of what division? How to divide? Answer: NC machining of parts, according to the general principle of the process of division, division method: The tools used by Division: that part of the process to complete the same tool as a process. According to the number of installation division in that part of the process to complete the installation of a procedure for. According to the machining division: rough machining is a process, a process for finishing. The division according to the processing site: to complete the same type of that part of the process as a process. 3, to division stage of processing is what? 1), ensure the machining quality 2), the rational use of equipment 3), to facilitate the timely detection of blank defects 4), easy to arrange heat treatment process 4, w