广联达更新.tet（Glodon.Tet update）.doc

广联达更新.tet（Glodon.Tet update） GGJ2013 12.0.1.116 Data interchange for trade I. new calculation: 1, single component parameter input, add new 11G101-2 atlas. Longitudinal stress reinforcement by double beam, 2 (or multiple) arrangement, between two layers of reinforced steel bar cushion should be short diameter larger than 25mm, to ensure the spacing between the layers of steel. In the calculation of the beam, the coupling beam and the foundation beam, increase the beam pad iron calculation settings. Two, calculation and improvement: 1, Liang Duan encountered different types of bearings, algorithms are different, need to be set separately. In the node setting, the floor frame beam, the roof frame beam end node, the discrimination column, the vertical wall and the beam are used as the support, and when the different bearings are fixed, the corresponding nodes can be adjusted. 2, increase in the calculation of the beam settings: beam in parallel to cross the wall as a support. This setting defaults to no. If you encounter the above situation, you can change the setting to yes, and the beam can correctly identify the support. 3, in the independent base, a base, cap, column, beam and foundation connection beam properties in the deduction board / raft board (bottom) band attribute value added one button option, to handle the raft, in case of a plate reinforced foundation member through a disconnect alternately the layout of the situation. Three, new features: 1, the automatic erection of vertical reinforcement - - some engineering stand vertical bars in the structure of the general description of the unified description, such as: beam upper frame, vertical reinforcement configuration, except to indicate that, all use 2B14. On the beam (or base beam) layer, the frame can be quickly generated by using the automatic generating frame bar. 2, automatic generation of seismic design code for buildings - beam beam arrangement has certain requirements, the automatic generation of r