插座设计（Socket design）.docVIP

插座设计（Socket design） You dont know is civil or factory, if it is the lamp residential does not need to calculate the 8W lights to the middle of the room and put on the line, basically is a room for a large room, if appear larger then the corridor corridor also put a note and toilet lamp switch the living room made the best switch to adjust the brightness of more than! Ha-ha。 If it is necessary to calculate the plant Office of course, but more trouble ah ah ah glare illumination power you have to have these parameters (the supplier will give). Im here to do this relatively simple, power with GB50034-2004 16 page table can be done to calculate the total area multiplied by the unit area and power divided by the lamp is good, then use the software for the average layout in the house, so the result is to meet the requirements of the basic and simple. As for the socket, I seem to have read an article before. Its quite good. Recently, I did that as well: 1 living room socket layout, installation height and capacity selection 1. 1 living room layout socket The living room is the people watching TV, singing parlor, Cara OK, living centers, major household appliances (audio amplifiers, VCD machine, machine, air conditioning, reverberation) floor lamp, quartz heaters, telephone, TV, computer, printer, fax machine, etc.. (computers, printers, fax machines should be placed in the study, but considering most of the citys current residential no study, had to put in the living room). From the use of these household appliances, we can find the weak (television, telephone, double socket) socket position is determined, strong (power) multi-purpose socket, at least 4 groups on the corresponding determination. The horizontal distance between the strong current and the weak current should be more than 0.5m. If the distance is too close, the strong current will cause electromagnetic interference to the weak signal, which will affect the viewing effect. Colour TV sets and audio equipment mu