液塑限试验步骤及结果整理方法（Liquid plastic limit test procedure and result finishing method）.doc

液塑限试验步骤及结果整理方法（Liquid plastic limit test procedure and result finishing method） The liquid plastic limit test procedure and result processing method. Answer: (1) the test steps are as follows: The 0.5mm screen under the representative soil sample 200g, divided into three soil containing dishes, distilled water with different amounts of water, soil samples respectively under the control of the liquid limit (point a), slightly larger than the plastic limit (c) intermediate state and the two (point B), with the tone the knife frame, placed above 18h, the determination of a pointcone depth (20 + 0.2) mm, the determination of C pointcone depth below 5mm. The soil samples prepared by mixing in stratified soil cup, compaction, so that air escapes. The soil samples will be installed on the lifting seat of the cuvette determination on the cone tip and the soil to be just contact cone whereabouts, 5S readings of cone depth h1. The change of cone and soil contact position, the measured cone penetration depth of H2, H1 and H2 allow the error of 0.5mm, you should redo, at H1, the average value of H2 as the point of the cone penetration depth H. The tip of the cone to remove the Vaseline, soil samples collected from more than two 10g, determination of the moisture content, water content calculation of average value of W. The repeat experiments were performed on the other two water content of soil sample, the cone penetration depth and moisture content. (2) results as follows: In the double logarithmic coordinate paper, with water content as abscissa and cone penetration depth as the ordinate, a, B, C drew three points, even the 3 point should be in a straight line, 3 points is not in the same line, to a and B, C two even two according to the liquid limit line, Richard HP, in the hp-w1 chart, the HP in H-W graph AB, AC two on the line for two water corresponding rate. When the difference between the two water content is less than 2%, with the average moisture content of a and the