机电专业（Mechanical and electrical specialty）.doc

机电专业（Mechanical and electrical specialty） A, Practice purpose Through the practice of heavy smelting, It can make us contact and copy in practice Some of the relevant professional work, training and training, we use the basic principles learned On basic skills and professional knowledge, Ability to analyze and solve practical problems independently On combining practice with practice, Improve our practical ability, For the future, well leave after graduation Work on a certain basis. Two, internship content One Among the measuring indicator, micrometer in the machine Use in work One , Before use, check the flexibility of the measuring rod movement. When the measuring rod is pushed lightly, the measuring rod is in the position of the measuring rod The movement of the sleeve should be flexible, There is no card rolling phenomenon, And every time you relax, The pointer can revert to the original Graduation position. Two , Measuring time, Do not exceed the measuring range of the measuring rod ; Dont hit the measuring head suddenly On part ; Dont make the dial indicator is vibration and severe impact, also do not put the parts into force Measuring head, Mechanical dial indicator of the damage or loss of precision. Therefore, With a dial indicator measuring table It is wrong to have rough or rough surface parts. Three And with the dial gauge calibration or measurement of parts, should make the measuring rod has a certain initial force. That is, when the measuring head comes into contact with the surface of the part, Rod shall be Zero point three ~ 1mm Amount of compression ( Small dial A little, yes 0.1mm that will do ) Turn the pointer about half a circle, then turn the watch ring so that the dial is zero Line alignment pointer. Pull the round head of the portable measuring lever gently, Pull up and relax a few times, Check what the cursor refers to Is there any change in the position of zero?. When the zero position of the pointer is stable, Then start measuring or cor