砌体施工（Masonry construction）.docVIP

砌体施工（Masonry construction） One, overview of masonry engineering The contract for the masonry construction drawings and instructed by the engineer of masonry project, including the former pool, dry stone masonry and precast concrete frame lining; Sluice Downstream apron, scour trough lining lining; Shahe diversion project; diversion channel lining; other permanent and temporary works masonry masonry. The masonry structure is 100 ~ 200mm and 300 ~ 500mm thick gravel cushion thick masonry mortar, numbered M7.5 ~ M10; 400mm thick dry stone; 1000mm thick riprap erosion trough. Detection of the inspection and testing of raw materials and engineering quality, engineering two 1, inspection of raw materials: The masonry engineering involving raw materials to be tested are: cement, sand, geotextile, closed cell plastic foam plate, gravel and stone. The above six kinds of raw materials in procurement, in addition to the owners specified in ISO9002 quality system of the company into the purchase of qualified suppliers, materials shipped to the construction site, in the presence of the Engineer in accordance with the specification for sampling inspection, closed cell plastic foam board, cement, sand and gravel test with fifth section of concrete engineering. The test results of raw materials if not qualified, identify and isolate return appearances at the construction site; if the material submitted to the engineer after the examination and approval of qualified, identified and put to use. 2, the cement mortar mix ratio test: The main material for cement mortar masonry masonry. According to the design requirements of labeling, extraction after passing through the test of cement, sand, cement mortar mix to work site laboratory. The mix ratio test results to the engineer can use after examination and approval. 3, engineering quality inspection process: In masonry construction, the need for the construction process of the project are: detection and cutting slope, Geotextiles laying