结构设计原理（Structural design principle）.docVIP

结构设计原理（Structural design principle） 1. which of the following is not the advantage of reinforced concrete structures? B A. easy to use B. is good in modulus C. good durability D. good crack resistance 2. the basic value of various mechanical indexes of concrete is a A. cube compressive standard strength B. cube compressive design strength C. standard strength of axial compression D. axial compressive design strength 3. hot-rolled steel bar after cold drawing, a A. yield strength increases, but plasticity decreases The yield strength of B. increases, but the plasticity remains unchanged C. yield strength increased, but plasticity increased The yield strength and compressive strength of D. increase, but the plasticity decreases Four 5. the serviceability limit state is compared with the serviceability limit state a A. allows a higher probability of failure B. has the same probability of failure The probability of failure of C. is smaller D. allows the occurrence of failure probabilities to differ little 6. this section test: the minimum reinforcement ratio in the beam control is to prevent the occurrence of C A. baroclinic failure B. shear compression failure C. oblique tensile failure D. cant prevent it Ultimate bending moment of 7. super reinforced beam B A. has nothing to do with reinforcement ratio and concrete strength grade B. basically has nothing to do with the reinforcement ratio C. basically has nothing to do with the strength level of concrete D. is related to the reinforcement ratio and the strength grade of concrete 8. where is the tension zone of the reinforced concrete beam when the tension zone begins to crack? D A. achieves the actual tensile strength of concrete B. meets the tensile standard strength of concrete C. meets the tensile design strength of concrete D. reaches the ultimate tensile strain of concrete 9., the long-term stiffness of the beam with compression reinforcement is mainly due to B A. similar to the upper flange B. can reduce the inf