结构相关说明（Structure specification）.docVIP

结构相关说明（Structure specification） The structure of professional uniform technical measures of a project (electrical part) A, general information 1, structure: Shear wall structure (top) Frame structure (pure basement, commercial, kindergarten) Shear wall (including individual short limb shear wall), seismic grade: Three 2, the structure of irregular rules: 3, design earthquake group: group second, II site, Tg=0.40s 4, the seismic fortification intensity of 7 degrees, the acceleration of 0.10g 5, the cycle reduction coefficient: 0.85 (18), 0.9 (26), 6, calculate the number of modes: The top 15 or 18 (usually adjust the computer when 9 or 12 desirable to save time, construction plans with 15 or 18) Business 6 9 kindergarten 7, considering the accidental eccentricity and bidirectional earthquake (according to the procedures for greater value, were calculated with the specification does not conflict) Considering the coupling A diagonal member, still need additional horizontal seismic direction corresponding 8, the simulation of construction loading: 3 (usually adjustable electrical load available is 1 to save time, pay attention to the axial compression ratio by 3 loading control) 9, the beam stiffness reduction: 0.7, when a large number of beam reinforcement beams when super desirable 0.55~0.7, only a few relatively small cross high should separate review, should not be the total parameters of connection stiffness reduction coefficient is too small. The other note: both ends of the shear wall plane and span ratio is less than 5 of the beams beam, beams should intervene in the special non component information in. 10, wind load calculation, shape coefficient of 1.4, basic wind pressure: 0.3 (18 and below), 0.35 (26), the ground roughness category: B In 11, the stiffness amplification coefficient: 2 beam torque reduction coefficient: 0.4 12, only in the calculation of displacement, check the floor stiffness is infinite, the rest are not checked floor stiffness infinite. 13