西安某小区高层住宅楼填充墙施工方案.docx（Construction plan for filling wall of high-rise residential building in a residential district of Xian.Docx）.docVIP

西安某小区高层住宅楼填充墙施工方案.docx（Construction plan for filling wall of high-rise residential building in a residential district of Xian.Docx） All the exposed face by cement mortar. (7) a piece of brick masonry wall at the bottom of the plain concrete hollow masonry pouring compacting On the bottom block. (8) when building on the wrong seam, using the method of block masonry mortar bedding, horizontal and vertical, The mortar. The level of ash seam shall not be less than the full block 90%, the full degree of vertical mortar joint Below 80%, appear blind seam and transparent seam shall not be masonry, horizontal mortar joint and vertical mortar joint width In the control of 8~12 mm. When the lack of auxiliary specifications block, masonry walls should not exceed two Skin block, door opening on each side to bury 3 pieces of brick, and the door from the top 150 of the buried piece, from the ground A 1000 mm depth. Around the windows for masonry hollow brick block with reinforcement frame C20 mixed Concrete through dense, solid side toward the window, door and window masonry must ensure the hole size. (9) the construction of structural column and reserved hole, need to keep a horse tooth trough, horse tooth trough back first In depth of not less than 120 mm, and the wall block is left foot hand eye, such as to stay The available auxiliary block side built, using the hole as a foot hand eye, but not in the following parts of masonry Set foot hand eye: The upper and the lintel, Liang Cheng 60 degree triangle and lintel span The range of 1/2; The span is not greater than 800 mm wall between windows; Under and around the beam Within the range of 500 mm; The two sides of the entrance doors and windows 200 mm and masonry junction 400 mm range Design regulations do not allow set foot hand eye position. Three (11) lintels should according to the drawings, specification and Atlas requirement is prefabricated, a beam anchor The wall length of not less than 250 mm, the reserved hole should