轧钢工艺流程（Rolling process）.docVIP

轧钢工艺流程（Rolling process） Billet sent from the steelmaking plant, first into the furnace, and then through the rolling mill rolling after entering the finishing mill. Rolling pressure of metal processing, said simply, rolling plate as pressure noodles, after repeated extrusion and pushing the rolling pin of the surface, the more of the rolling thin. In the hot rolling production line, rolling billet heating become soft, the roller into the mill, finally rolling into the size of user requirements. Rolling is a continuous uninterrupted operation, the strip in the running speed roller, high degree of automation equipment, high efficiency. Out from the open hearth furnace steel ingot can be steel, but first of all, after heating and blooming can be sent to the hot rolling line, continuous casting process to switch to the more simple, general slab thickness is 150 ~ 250mm, after the removal to bloom, the roller into the finishing mill, finishing mill from 7 and 4 mill, equipped with machine guns before the roll and the flying shear, resection of the head board. The finishing machine speed can reach 23m / s. The product is divided into hot rolled steel coil and two ingots plate, the thickness of the hot rolled rail after a few millimetres in, if the user asks the plate thinner, but also after the cold. Compared with hot rolling, cold rolling mill processing line scattered, cold-rolled products are mainly cold-rolled plate, coating plate is tinplate, galvanized and color coated sheet. After the hot-rolled steel coil plant sent first, after three consecutive treatment, to remove the oxide film with hydrochloric acid, and then sent to the cold rolling mill. In the cold rolling mill, steel roll uncoiling machine will be opened, and then strip into five stand tandem mill into thin strip. From the five rack there are different specifications of the ordinary steel coil, it is based on a variety of user requirements for processing. The production of various products of different qu