道路交叉（Road intersection）.docVIP

道路交叉（Road intersection） Step 16. intersection facade design method Answer: the methods and steps of the intersection of facade design 1. data collection (1): the control of elevation measurement data and control coordinate intersection; collected or measured 1:500 or 1; 200 topographic maps, detailed annotation Near the floor and building elevation. (2): Road intersecting road grade, width, radius, longitudinal slope, cross slope and the horizontal and vertical design and planning. (3) data traffic: traffic volume and traffic composition (straight, left and right ratio). (4): drainage position and size have been built or to be built on the ground and underground drainage canal. 2. draw the intersection plane graph Including: the center line, the width of the sidewalk, roadway and curb radius, grid line. 3. determine the design range of intersection Outside the scope of design for curb radius cutoff 5m ~ l0m (representing a grid), which is given to the self dual cross slope gradually transition to the A certain distance one-way cross slope is needed, and should be fully connected with the intersection of road pavement elevation. 4. determine the facade design pattern According to the intersection of the road grade, slope direction, topography and drainage requirements, determine the form of contour elevation design, and according to the longitudinal The size and height of slope accuracy requirements of the selected adjacent contours is generally 0.02M ~ H 0.10rn, even for computing). 5. design the elevation on the road (usually represented by contour, see figure 1.6.13 design). 6. design the elevation of the intersection. (1) to select a proper road ridge line intersection range and elevation control The so-called road ridge line is the crown apex (water connection point). (2) to determine the elevation calculation line and calculate the elevation of the points on the design elevation calculation The elevation of the calculation to determine the line network can use: