钢筋计量（Reinforcement measurement）.docVIP

钢筋计量（Reinforcement measurement） Some of the reinforced concrete measurement problems and solutions (from construction of) In the frame and shear wall structure, the reinforcement works as a major part of civil engineering, greatly affecting the quality of the project, and the proportion of the cost is also very high. According to many years engaged in the settlement of practical experience, while some easy to produce and easy to cause the measuring error log dispute and its solution are introduced, to a certain extent, taking into account the economic rationality of the use of steel in design and construction considerations. First, to look at and understand the map is the first step for the budget staff to start work. For the current widespread and reinforced iconographical, my deepest experience is: the iconographical simplified construction drawings of reinforced concrete structure, and reduce the design workload of drawing, but also correspondingly cause budget personnel more difficult figure drawing. It should be said that flat legal map prominent features, manifested in the beam concentrated tagging and in situ tagging on. Mark is from the beam plane lead out beam number, span number, cantilever beam type, section size, spacing and number of limb long stirrup diameter reinforcement (bottom reinforcement or gluten) diameter and root number, lateral or longitudinal structure beam torsion steel bar diameter and number of roots. Such as centralized Annotation has long gluten, bearing negativereinforcement number in situ Annotation contains number of full-length gluten. In addition, in the concentrated mark design, the beam end of 45 degrees or 60 degrees bent steel bar settings, instead of using an encrypted hoop to bear the shear strength of the oblique section. In the design drawings of concentrated labeling, the most easily controversial issue is the layout of the beam bottom reinforcement. Most of the time is in each span continuous beam bottom reinforcement of