钳工试题 与答案（Locksmith examination questions and answers）.docVIP

钳工试题 与答案（Locksmith examination questions and answers） I. judgment questions 1, in order to make the parts have complete interchangeability, the geometry of each part must be exactly the same size. 2. The actual size of the part is between the two given limit sizes, and the part is of qualified size. 3, the matching of holes and shafts, the basic dimensions must be the same. 4, the actual size of a part is exactly equal to its basic size, then the size is bound to pass. 5, measurement accuracy and measurement error are two relative concepts, the accuracy is high, the error is small, otherwise, the accuracy is low, the error is large. 6, because the random error produced by many factors with contingency and instability, so in the higher accuracy of the measurement, can only ignore this error. 7. Using the same precision measuring instruments, the direct measurement method is more accurate than the indirect measurement method. 8. The purpose of setting geometrical tolerances is to limit the shape and position errors so as to ensure the performance of the parts. 9. The value of the non tolerance of the form tolerance shall not be marked and explained in the drawings and technical documents. 10, the circle jitter tolerance is divided into four kinds, and the division is based on the geometric characteristics of the measured elements and the direction of detection. 11. The elements that are actually formed by the machined parts are the elements to be measured. 12. It is similar to the relation between straightness tolerance and flatness tolerance. The shape of line tolerance zone is more complex than that of surface profile and tolerance zone. 13, for a certain hole, its in vitro action size is larger than its actual size; for a certain axis, its in vitro action size is smaller than its actual size. 14. The essence of a reversible requirement is form tolerance, which in turn compensates for dimensional tolerances. 15, improve the surface quality of the parts groove and st