焊接质量控制（Welding quality control）.doc

焊接质量控制（Welding quality control） 1 Purpose In order to standardize the unified quality standard in EPC project and standardize the professional quality management behavior of welding engineering, this quality regulation is formulated. 2 scope of application These Regulations apply to the quality control of site welding in EPC project. 3 responsibilities 3.1 construction units (sub) to manage the preparation of welding WELDERS; technical documents; equipment and welding operation of welding materials, welding quality management; responsible for project site welding. 3.2 EPC, supervision institution Supervise and check welders on duty; review contractors welding technical documents; recheck welding materials and welding equipment; supervise welding process; organize special inspection of welding quality. 4 management content 4.1 General Provisions All site welding of the 4.1.1 EPC project will be subject to the requirements of the present regulations in addition to the relevant specifications and requirements; 4.1.2 if the construction unit has special requirements, it shall also carry out the special requirements of the construction unit. 4.2 content 4.2.1 construction unit personnel requirements (1) welding engineer should have above (above) technical titles and over one year welding construction experience. Responsible for the qualification of welding procedure, welding procedure, welding process instruction / card and welding construction plan, guide the welding operation, welding quality management in welding technology, processing, finishing completion data. (2) the welding quality inspection personnel shall be the professional engineer (inclusive) above the title of a technical personnel or technician as responsible for the construction quality of spot welding; to conduct a comprehensive inspection and control, approval in welding technology documents, with the supervision organization, the third party inspection unit to determine the detection and evaluation of