mac地址修改大法（MAC address modification method）.doc

mac地址修改大法（MAC address modification method） Sender: Chenli (wind and rain life), letter area: XMUNET Title: Mac address modification method Return: Gulang (Sep 12 17:12:57 2001 Wed Kikunami), again Five ways to change the hardware address of the network card If your legal network card is bad, youll have to buy a new one, and you wont bother to go Re registration, then this article may be useful to you. Disclaimer: no illegal activities shall be used in this article! (1) first look at the network card SETUP program, that is, you can change the interrupt number, IO address of the kind Program, if youre lucky, there might be NodeAddr or something like that Options. Ive seen a lot of network cards can be directly changed the address, I use this Slice is. (EDIMAX EN-2000PXT[ISA 60RMB red packaging villages are everywhere] set MAC Address setup /i [instructions are not available on the /i option] ) Slice is. (2) if (1) doesnt work, try adding some parameter to the SETUP, /A, /B, /C, one by one If youre lucky, maybe you can happen to hide the hidden functions in SETUP To. Some of the cards SETUP has been tried out, it seems that someone in the BBS POST. (3) if you firmly believe that your SETUP has this function, its only been dropped by DISABLE The manufacturer must use some program to set the initial value. This program is most likely to be This SETUP on your floppy disk, and (2) can not try again, there is a stupid way: Solve it with SOFT-ICE, someone here has done it. (4) all of these are soft methods. If they are not available, they will have to be hard. If yours The NIC is not very old. It must have a EEPROM on it. I bet it is 93C46, eight legs. If Im right, then you can take it apart DIP8 socket), put a change on the line on the programmer which has 6 bytes is. What interests you?. It doesnt matter if its not 93C46, as long as your programmer supports it The chip will do. Ive tried this method. Yes, that old antique network card might be used Its some kind of old EPR