节气门匹配（Solar term door,）.docVIP

节气门匹配（Solar term door,） There are many vehicles to be re set in, after carrying out repairs now, grace A33 is the same as replacing IACV-AAC valve, ECM, solar term door after cleaning / replace to re set the matching. You can use artificial methods set. Artificial setting methods are as follows: 1 start the engine, the engine reaches normal working temperature, 2 check whether meet the above condition adjustment 3 turn off the ignition switch Wait at least 10 seconds 4, start the engine idle for at least 30 seconds 5 unplug the solar term door position sensor wire harness connector (brown) in 5 seconds on reconnection, 6 wait for 20 seconds Ford Fox (1) the minimum opening initialization method. The ignition switch on M block (starting engine did not step on the accelerator pedal), waiting for more than 15S, disconnect the ignition switch and wait for 20S, let the engine electronic control unit records data. (2) the maximum opening initialization method, the ignition switch on M block (starting engine), will accelerate the pedal to the floor, waiting for more than 15S, disconnect the ignition switch and wait for 20S, let the engine electronic control unit records data. 7 make sure the engine idle speed standard, otherwise it should be re adjusted, 8 the engine running in high speed 2-3 times, are in line with the standard to confirm the idle speed and ignition timing The manual, solar term door! According to the online presentation 1. key 10 seconds off the door 2. open ON for 3 seconds 3.5 seconds of continuous throttle opening and closing action is repeated 5 times 4. wait for 7 seconds 5. throttle to keep 20 seconds (if the engine light flashes to the previous step) 6. wait 3 seconds after a car Tiida A flashing yellow light, on behalf of the previous step has been completed (if the number of time allowed, light is not flashing), loose throttle pedal + start the engine immediately after three seconds and then flash on the end of eight after the change, the engine