3200故障表（3200 trouble table）.docVIP

3200故障表（3200 trouble table） Otis3200 fault code Source of failure: system execution Fault code server display instructions 2000 STM software reset board software running error, causing CPU reset. 2001 STM power on reset power on reset, or press the reset button. The voltage of the 2002 STM power fail 5V supply is below 2.5V. System shutdown during system loss of power. 2005 STM not available some abnormal conditions are detected by MCSS, and other fault records should be checked. In addition, this record is also in emergency or repair status Source of failure: location reference Fault code server display instructions 2100, PSR, Big, POS, slip, and the elevator running in line with the direction of the rope slippage is too large. 2101, PSR, Big, neg, slip, and the elevator running in the opposite direction of the wire rope slippage is too large. 2102 PSR, Pos, MES, PVT, FLT read position is already in the flat area, but DZ has not entered, should check the photoelectric 2103 PSR Inv FLOOR COUNT invalid floor count, floor count inconsistent with the actual hoistway number, or exceeding the maximum or minimum floor limits. Generally occurs after the power failure, the car position has been moved, once again sends the electricity to have this breakdown 2104, PSR, Inv, raw, POS, PVT pulse number of abnormal change, check PVT and MCSS and DBSS connection 2105, PSR, DZ, error, DZ, input signal error 2106, PSR, DZ1, error, DZ1 input order error 2107, PSR, DZ2, error, DZ2 input order error 2108, PSR, 1LS, error, 1LS input order error. The elevator stops at the bottom, the DZ acts without the 1LS signal, or the 1LS signal moves before the 1LS switch. It is also possible for 1LS and 2LS to move simultaneously. 2109, PSR, 2LS, error, 1,2, 2LS input order error. The elevator stops at the bottom, the DZ acts without the 2LS signal, or the 2LS signal moves before the 2LS switch. It is also possible for 1LS and 2LS to move simultaneously. Note 1: the elevator performs an emergency