cad应用（CAD applications）.docVIP

cad应用（CAD applications） The ratio is a very important concept in AutoCAD, the proportion of the concept of this forum about AutoCAD many reports, but no systematic summary, there are several recent posts about this problem, so, I want to send a special concept of the proportion of AutoCAD topic in several posts do system introduction. Please correct me when there is any mistake. I. drawing ratio We used to call AutoCAD 1:1 drawing, and this 1:1 should be the concept of scale, but in fact, AutoCAD doesnt have any 1:n graphics. Lets not say first, the input 100 is 100mm, and strictly speaking, we input 100 graphic units, because we use metric, metric 1 graphic units in AutoCAD, that is 1mm. Drawing is according to the set of graphics units, according to physical drawing, 1m length line, you enter 1000, rather than because the drawing ratio is 1:100, enter 1000/100=10. In this way, the AutoCAD drawing actually does not have the concept of drawing scale. Two, print proportion In the actual project may not be much real draw much of the drawings, that is to say in the computer AutoCAD graphics files it is not only a graphic drawings, and electronic documents, to turn it into a real physical drawings in requires 1:n to print the chart. 1:100 printing, 100mm is the length of a line of print to 1mm long, in other words, if the 1000mm file on the line through the electronic drawings to print, is 20mm, it is called a 1:50 to print out the map (1000/20=50). Because of this, drawing with AutoCAD, wed better interpret the scale of drawings as a more appropriate proportion of the printed drawings. Three, there is no proportion of physical objects, non physical only proportion Since the size of the AutoCAD is large, there is no proportion of the actual object. However, non physical drawing information, such as text, dimensioning, symbolic graphics. There is no proportion of the original saying, but in the proportion of AutoCAD, why? Because electronic documents are printed into phy