ghost参数详细说明（Ghost details）.docVIP

ghost参数详细说明（Ghost details） The Internet is usually used with disk workstation. Due to various reasons caused by the breakdown of the system and so on, the hard disk data backup and recovery maintenance is always very heavy work. It is one of the most common Ghost disk operation tool. When the step-by-step operation might waste a lot of time everyone here, and we share the use of Ghost parameter that can be written in a batch file to control the backup and recovery process so as to save everyone! We ghost time! Take more time to learn more advanced knowledge and more global PPMM The batch file Ghost not very good writing, firstly introduce the basic format: Ghost-clone, mode={copy|load|dump}, src={drive|file|drive:partition}, dst={dri-ve|file|drive:partition}/fro/fx/rb/f32/Z (n) /sure{} other parameters The meaning and usage of the main parameters are as follows: -clone:clone is a clone in English, here is a fixed format, meaning to perform Ghost.exe mandatory parameters. Mode=: this parameter is used to set the Ghost.exe mode, there are six models available: copy, pcopy, load, pload, dump, pdump. Among them, copy, load, dump refers to the disk to disk operation, with P (pcopy, pload, pdump) is operated in the same mode for hard disk partition. Such as mode=copy means a hard disk data inserted into another one of the same capacity or larger, plus P (mode=pcopy) after the means to clone a partition of the data to another partition. The meaning of mode=load is to extract the image file to the hard disk recovery (or partition), mode=dump means the hard disk (or partition) made of image file. Src=: this parameter is used to set the data source location, with 1, 2, 3...... Representatives of different sources, such as src=1:1 said data from the main dish in the first division, src=2:2 said data from the disc from the second partition, src=d:\ghost\sysbak.gh1 means to extract data from the main disk partition second sysgbak.gho file in the Ghost directory. Dst=: the parame