同学会聚活动策划方案.doc

毕业十周年聚会活动策划方案 一、邀请函 亲爱的同学： 一队小小的漂泊者，南昌加州旅酒店公 南京 4月30日 K1191 K1328/1325 硬卧154 5月1日6点左右 250元 上海 5月1日前 太多了自己选 二等座237 7个小时车程 333元 福州 5月2日前 太多了自己选 二等座200 3个半小时车程 296元 广州 4月30日 车次较多，建议选择晚上发车，早上到达 硬卧230-278 5月1日7点 374元 酒店房间： 应急预案 确保人员平安到达预案 1、南昌本地人员做好随时接站任务， the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compar