授予学士位条件的FAQ.doc

本科毕业生授予学士学位的FAQ 我院从2007级秋季入学的本科学生开始施行《浙江大学成人高等教育本科毕业生学士学位授予工作管理办法》，为了使学习中心老师和同学更好地了解授予学士学位的相关规定，我们就一些常见问题回答如下： ● 专科起点本科学生和高中起点本科学生申请学士学位要符合哪些条件？ 答：申请成人高等教育学士学位者，应具有良好的思想道德品质，遵纪守法，并符合以下条件： （一）完成学校规定的相应教学计划的各项要求，经审核准予本科毕业。 （二）三门学位课程（一门基础课、两门专业课）平均成绩70分（含70分）高中起点本科课程门起点本科课程门毕业论文（设计）成绩以上（含）三门学位课程（一门基础课、两门专业课）平均成绩70分（含70分）三门学位课程（一门基础课、两门专业课）平均成绩70分（含70分）高中起点本科课程门起点本科课程门（设计）70分等情况），可申请延期毕业。曾经办理了申请延期毕业的学生，如已符合学位条件要求毕业或放弃学位申请而想要毕业，必须取消延期毕业。申请延期毕业或取消延期毕业，必须在学院规定的时间内在网上操作，逾期不予受理。 ● 学生在毕业的最后一个学期参加大学英语四、六级等考试，成绩在毕业前还不知道的，怎样申请学位？ 答：学生如在毕业成绩合格者可凭在申请学士学位，逾期不再结合课程 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler ga